Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / saravanan
We can not generate 400KV, because for 400KV Insulation
level is high. we can not manufacture the generator with
high insulation level.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
Differentiate between voltage and current feedback in amplifiers?
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
How to select the proper VSD to operate high inertial load
What is ST and specify its range of voltage.
how to deside the capacity of chock for drive?
What is stacking factor? What is its approximate value?
how we calculate the short circuit capacity of the busbar in LV & HT?
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
by what factor the starting current is used when comparing star and delta connection for motor starting?
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
how to electronic energy metter failed in electomagnectic fild passing in the metter and which thing to defect more on metter.
How you will determine the volume of oil in a particular Distribution transformer.
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
