What is UJT PNP, NPN transistor & working principles?
- 1 Answers
- 12008 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / saiful islam
PNP configuration
NPN AND PNP
PNP transistor:
When common base connection of a NPN transistor.In the
forward bias connection of the first PN junction ,it causes
the majority charge carrier(holes) in the P-type ,flow from
emitter to the base region .This constitutes the emitter
current (Ie) in the transistor.As these majority carrier
(hole) cross in to N-type base .They are combine with the
electron .Only the few hole (i.e less than 5%) combine with
the electrons ,because the base of this transistor is
lightly doped and very thin .Expects those holes ,all other
i.e More than 95% cross in to the collector region.This
constitutes collector current (Ic). In this process ,almost
the whole emitter current (holes) flows into the collector
region .So in this transistor ,current conduction in the
circuit is by holes.
Ie=Ic+Ib
Where ,
Ie=emitter current,
Ic=collector current and
Ib=base current
NPN transistor:
When common base connection of a NPN transistor .In the
forward bias connection of the NP junction,it causes the
majority charge carrier(electrons)in the N-type ,flow from
emitter to the base region.This constitutes the emitter
current(Ie) in the transistor.As these majority
carrier(electrons)cross in to the P-type base.They are
combine with the holes.Only the few electrons(i.e less than
5%) combine with the holes ,because of this transistor is
lightly doped and very thin.The remainder i.e more than 95%
cross into the collector region.This constitutes collector
current (Ic).In this way the whole emitter current
(electrons)flows into the collector region .So in this
transistor, current conduction in this circuit is by electrons.
| Is This Answer Correct ? | 13 Yes | 5 No |
Post New Answer View All Answers
What happens if we run alternator on under frequency?
is there any phase difference occurs while primary and secondary side mutual induction occurs?
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
Explain the advantages and disadvantages of hydropower plant?
What is the difference between the impedance percent and impedance voltage ?
physical identification of HT & LT panel
Why control of DC motor is simpler?
Thumb rule of cable size(rm>30 rm)X multiplying factor=ampere
How relay coordination has to be done? what are the inputs are required for this? Please explain this with calculation method?
Please explain, how to test vector group of tranformer(Delta y1) . Thank
Do u know any one? how to find out in motor rated amps? formula?
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
I Want randstand placement papers
how can we calculate the ratio of caustic soda and water in lrs.
I have motor 1500 HP and , 4160 V , 60 HZ , then i need the rating of transformer which can feed that motor ??
