Answer Posted / balaji
DCS is nothing but Distributed Control system.It is used to
control the process of distributed instruments.
| Is This Answer Correct ? | 10 Yes | 3 No |
Post New Answer View All Answers
where cascade loop use ?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
use of split range ? where it is used ? in which control loop it is used ?
how 3 out of 2 Logic/interlocks works? give brief explanation with help of diagram.
diff between neutral ,ground,phase , earthing and shielding?
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
how to calibrate 0- 150 psi presure gauge by dead weght tester
What is the purpose of the analyzer in petrochemical plant?
What are primary elements of measuring pressure?
What is limitation of the ht.of the displacer of a level trol?
What is the start up procedure of desalter
Explain the mechanism behind the turbine meter.
Whatis the reset ofset and control system in instrumentation
What is the difference between ff transmitter and non ff transmitter
what is droop in governer ,type of droop ,how it work
