Hi, i
want to
know is
meant by
power
quality?
How it
can
calculated ?
How we
can
improve?
- 1 Answers
- 3236 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
without changing in voltage and curent rating
p=q/v
using accruit valu resistance
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
The loads are connected with phase and ground then why current flow as the loads ?
why i can not use thimble on capacitor duty contactor
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
During Starter Panel Com missing I Found The Main Incomer 40Amp MCB 10KA Trip When Motor Change Star To Delta Motor Rating 20HP BUT When We Use Same MCB To Other Motor It Does Not trip Or What Is Necessaries for Star Delta Starter MCB SFU MPCB OR MCCB And What are The Breaking Capacity of MCCB in the Motor above 15HP
What is lifting power for 1 wb/m2 and 1 A magnet?
How to setting the volume of RTCC panel AVR (11kv) controller
Please provided formula for calculate the cable size from step up transformer to M.V panel, run overhead aluminum cables, total load is 5mega watt, total length 900 feet.
what is the reason for indication of light in the earth lamps of main switchboard.if there is an earth why does one lamp get dim and the other two bright.
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
what do w do when the output of generator is fluctuating?
A cylindrical wire is compressed in length by 10%. The percentage decrease in the resistance will be?????
what is strip power factor?
Practical condition in 400KV Sub station:- Breaker(open) , isolator(open), Earthing (close) at both end e.g A & B. Now Open A Stn Earthing than Open B stn Earthing (Which have a 50MVA reactor) , AND suddenly show R,Y,B phase 704KV,573KV,118KV respectively. Que is without closing of breaker how it is possible.???? My Whats app No:07621840498 for Further Discussion. Pls experts suggest.
For RCD (Residual current device) Icu is defined. How i can find Ics for them?
