Interested to Buy Any Domain ? << Click Here >> for more details...
how the actually positioner of control valve working?
where we gave 3-15psi pressure to I/P converter where it is firstly applied ?- on I/P to positioner then what happen?
is control valve operate on 3-15 psi or its bench pressure?
- 2 Answers
- 6476 Views
- I also Faced
- E-Mail Answers
Answer Posted / himanshu amin
valve positioner is having three air connection. 1. Air
supply,2. i/p 3 to 15 psi from i/p converter. 3. o/p to
control valve. suppose you are giving 9 psi to valve
positioner. valve positioner will supply o/p for 50 % valve
opening. the feedback arm of valve posioner will give
feedback to valve positioner according to valve position.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?
how can use ram
what is temperature compensation?
define feed forward control loop with example and drawing?
What is force balance principle? State some of its’ advantages.
Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?
i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
why any measurement made interms of pressure is more accurate ? to be more precise most of the flow velocity is made interms of pressure and it is accurate. what is the reason behind pressure measurement being accurate ?
Define the terms Accuracy, precission, Spam, process tolerance while doing calibration of an instrument? Explaini with an example?
how to calculate range of level transmitter?
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
how to turbine speed measurement?
If fire would be inside the plant which fire detector is to detected the fire.
