Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / tenon
Neutra: Neutral is Retern Path.
Eartth: Earth is Seafty device.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
How we can come to know the substation range,without go through any name plate ?
What is difference between start imitation and start interlock for 3 phase motor protection ?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What are the advantages of autotransformer?
describe the phenomena of vacuum interruption in C.B
What are IR values and what it should be for coil and for insulator
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
Explain the operation of grid connected central solar inverter ?
What do you mean by a phase angel of instrument transformer?
State norton’s theorem?
is it value of power factor is more than unit. whats effects in the source supply
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
whether fibre optic cable in high voltage earth conductor is used for protection circuits
Can clean earth cable be considered as low current cable
How to do stting of vl250 siemens MCCB
