Interested to Buy Any Domain ? << Click Here >> for more details...
In electronic board one fuse(rating 230v,100ma)showing 2.5
ohms with multimeter,then the fuse is healthy or not.
- 4 Answers
- 7609 Views
- I also Faced
- E-Mail Answers
Answer Posted / devi
yes,it is healthy.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
how to calculate range of level transmitter?
What is the purpose of LO Overhead tank in turbines.
why orfice is not used for main steam flow calculation
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
What is the start up procedure of desalter
What is Alpha & Beta fctors related to Orifice Plate & its relation with flow?
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
Give 2 application of quartz crystal used for process parameter measurement.
what is gas metering system? gas chromatograph? and gas compressors?
How it the difference between force balance system and dispalacement balance system?
What is motion balance principle?
What are primary elements of measuring pressure? Which type of pressure can be measured by these elements?
why we use cascade control and feed foreword control in 3 element control of boiler drum ?what is feed forward and cascade control system ?
what are the diff. in servo and regulatory control?
1.what is the effect of vapour presuure in orifice plate flow measurement 2.which is more effective 2 pressure sensors or one single differential pressure sensor in orifice plate measurement 3.how to design a v/i converter and i/v converter 4.how many type of thermocouple are there 5.how many leads are there in thermocouple measurement 6.how pressure sensors are connected in level measurement in differential pressure method 7.what is the output of capacitive pressure sensor (ac or dc),how its o/p is signal charactarized 8.what is the physical meaning of discharge coeeficient,why it is calculated,orifice plate what is its value,why it is less than 1,Q at upstream is equal to or not equal to Q at downstream of orifice plate why?what is vena contracta in orifice plate 9.why rotameter is called variable area flowmeter,it can measure flow even if area is not varying,why it is made tapered 10.design a 10 bit counter ,which counter you will prefer 11.how to remove self heating error in RTD 12.which is more sensitive pt100 or pt50 13.why thermocouple are connected in parallel 14.what is lead contact error in RTD,how to avoid 15.what is P,PI,PID,PD controller,why there is no ID controller 16.what is override,split range,sequential,ratio,feedforward,cascade controller 17.why we moved from SR to JK and then JK to master slave JK flipflop,give correct reason 18.how to measure level of a closed container which contains vapour and liquid,remember no vapour gas should be leaked,so ultrasonic and capacitive is not an option,design another method 19.how to design horse race counter including sensors and signal conditioning element 20.what is bevelling
