i have 2 motor of same rating. on no load condition one
motor take 1.6A but other motor is taking 4.8A. what is the
reason of this. please explain with proof.
- 8 Answers
- 8459 Views
- Ambuja, UltraTech, I also Faced
- E-Mail Answers
Answer Posted / sameer gupta
In case of 3 phase motors,
the motor takes higher current might have incorrect winding ratio which may cause unbalancing of 3 phase current.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
does any one know where we can purchase insulation oil for high voltage oil filled cables
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
TELL ME WHAT IS INDUCTOR AND CAPACITOR WHAT IS IT BASIC OPERATION ANDFUNCTION?
what is the effect of back reactive power on the generator ?
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
What is contract demand in solar system?
How Diesel Generator start ?
When the relative speed between the magnetic fields of stator and rotor does is zero under steady state operation?
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
what is load despatching
Why does the Solid state Rectifiers for 3-ph brake motors sometimes have 2 & sometimes 3 output terminals?
i completed my DEEE. and i want to electrical c license. how to get it..?
If I want to buy a new Xformer for my plant what are the main parameter will I need to check?
what is frequency response?
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
