Interested to Buy Any Domain ? << Click Here >> for more details...
what is the voltage between the earth & neutral
2 is there any continuity TO BE between earth & NEUTRAL
- 3 Answers
- 10700 Views
- Suzuki, I also Faced
- E-Mail Answers
Answer Posted / jais thomas
THE EFFECTIVE VOLTAGE BETWEEN THE N AND E OF A SYSTEM
SHOULD BE ZERO WHICH MEANS THERE IS NO SHORTING,
DEFINITELY THERE WILL BE CONTINUITY BETWEEN N AND E BECAUSE
THE N THAT IS GENERATED IN A STAR SYSTEM TRANSFORMER IS
GROUNDED WHICH MEANS THAT THERE IS A CONTINUITY IN N AND
E.THIS SHORTING BETWEEN N AND E SHOULD ONLY BE IN THE
TRANSFORMER LEVEL AND NOT IN ANY OTHER PART OF THE SYSTEM
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
mccb service sittings be done?
What is the function of RCBO? What are the different sensitivity ratings & each application?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
for compensate 315mh inductance ,how many capaciance required?
how the CT and PT is connected in the circuit during testing of transformer explain with diagram
what is smartµ grid technology?under coal gassification?
how to size H.T & L.T Panel ?
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
what is difference between window type and wound type transformers?where we will use window type and wound type transformers?
mccb service sittings be done?
how to calculate vfd o/p voltage by frequency
What is corkscrew rule?
What difference between ref protection and differential protection ?
Importance of fault current in power transformers and how to monitor the same? How is it different from winding temperature?
Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.
