Answer Posted / mohammed abbas
pressure transmitter is having two parts
first primary sensing device which is in contact with
process physical parameter like pressure and this primary
sensing devise sence the process pressure by various
method's like (LVTD,DP CELL,STARIN GAUGE AND ETC)and
convert this mechanical energy to electrical energy which
is also called as transducer and it is given to the
secandary sensing device of tx which is electronic part for
futher conditioning,to get (4-20) by using 24vdc excitation
voltage and secandry part of tx is also known as convertor
and the o/p of tx is given to indicator or controller
further manipulation.
their other std form of signal also as mentioned in above
answer by sateesh kumar sing
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
What is zero elevation and zero suppression?
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
Give 2 application of quartz crystal used for process parameter measurement.
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
Whatis the reset ofset and control system in instrumentation
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
What is frequency factor in massflow meter? When using frequency output?
can you provide me full detail about instrumentation in ONGC??
what is the difference between scaler and vector drive
What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?
Gas equation
Coal mill Instruments Equipments for cement plant And process diagram ?
any questions on motor and energy conversions machines?
