Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / abdul hakkem
for analog arithmetic calculation can be done only by Voltage, thats way 4-20 mA is converted & taken as a voltage output
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
what is interface level measurement.who can calibrate interface level measurement transmitter online
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
Explain the working of rota meter.
Explain the working principle of lvdt?
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
What are the uses of orifice plates?
can you send remote seal interface level transmitter calculation steps for oil water saperator.
what is the working principal of pribe
What is the use of double seated valve?
What is loop1 and loop2 in MTS LT?
Describe the function of Accumulator into the Pump
What is 3 element control system
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
