Interested to Buy Any Domain ? << Click Here >> for more details...
why is the vector group analysis done in transformer tests
- 28 Answers
- 75518 Views
- K K Rao, Lloyds, Nicco Engineering Services Limited, Qatar Petroleums, I also Faced
- E-Mail Answers
Answer Posted / rasool
1) the purpose of transformers based on vector group. (e-g)
for distribution purpose it is Dyn11
2)when your going to synchronise the two transformers it
must be the same vector group.
3) it is a common point that to measure the place
dispalacement between primary voltage and equlivalent
secondary voltage.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the one main difference between ups & inverter ? And electrical engineering & electronics engineering ?
how we calculate the short circuit capacity of the busbar in LV & HT?
hai now i am working as a electrical design engineer in construction field can i get a job in oil and gass field or power plant project as a electrical design engineer?
sir, i am 3 years diploma course pass out candidate.what type of certificate can i got in marine service.
Is Transol transformer oil comparable to nynas nytro libra?
What is the difference between PLC and Embeded system
is it possible to turn on the single phase star delta on delay timer using 24 v dc ?
block diagram of 2 ups system connected in parallel mode?
how generator load test is conducted?what are the steps?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
mention hazard experienced during installation
Difference between control junction box (cjb) and power junction box(pjb)?
What is reactive power and where it is used.
Why the output of OP-AMP is always less than Vcc?
Explain M Var? Which types of problem occurs when reactive power increase at the time of full load of plant and at the time of synchronize of plant?
