Interested to Buy Any Domain ? << Click Here >> for more details...
how to check the earth resistance value& what is the
minimum earth resistance for good earthing sysytem.
- 33 Answers
- 154484 Views
- Brookfield, BSNL, DMRC, Epoch, KPTCL, Polycab, Power Control, SIEA, Siemens, Wipro, I also Faced
- E-Mail Answers
Answer Posted / dipeandra deepak
normly earth res.value for an industrial area is 1 to 5
res.for rock sail area and residential area, this value is
8 and 1-3 res respectively.further ithink this depends upon
ur mant. capability. this can be maintened by checking
earthing pit time to time. it also depends the size of
earthing patti and the load capicity set against it.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
what will happen if synchronous machine rotor fed from single phase ac supply
explain wiring system
Its possible to use 3core 2R of 240 sq.mm cable for 3phases & separely 50sq.mm 3core cable fully for Neutral for connection of PCC to MCC 3ph..4wire system?
is that a problem if i connect a single phase load to a secondry delta connected transformer but i get a neutral from other transformer i the system?
What is Harmonics how it is produced and what is the method to control the same
how to failure indution motor insulation & how to improve heat in motor insulation
Explain and give examples about VCB?
can i use the six sigma method which is used in management area, in state estimation of power systems?
compare between starting charactristics of synchronous motor with those of 3Q Squirrel cage induction motor
what are the difference between AC lamp and DC lamp
I need the recommended size for a 3 phase transformer at 13.8 KV Primary and connected loads of 3000 kVA at 4200 volts and 2375 kVA @ 480 volts AC.
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
why the check zone and main zone are used for Busbar Protn. scheem?
how a flip flop can be used as a latch?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
