Interested to Buy Any Domain ? << Click Here >> for more details...
motor is 12.5hp after starting few minets motot get hot?
why?
- 5 Answers
- 7976 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Add 2 more 1.bearing faulty 2. improper cooling.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I am EEE student i want to improve my core side skills.how cn i approach it?
being an electrical engineer why you wanna come into software i have an very good academics what answer i have to give
If one tertiary phase i.e. R,Y or B is earthed of a loaded type tertiary delta connected (Without load)of a power auto transformer, what is its advantage/disadvantage?
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
for 5KW resistive load can anyone please suggest me whether to go for UPS/Inverter or Generator depending upon cost calulations
How do the synchronizing lamps indicate the correctness of phase sequence between existing and incoming alternators?
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
if the armature current in a dc generator is ac ( sinusoidal ) why doesnt the sjhape af armature mmf a sinusoidal (ni) ? armature mmf in case of a dc machine is triangular.
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
What do you mean by Frame 5 Gas Turbine as well as Mark II.
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
What are test signals and their significance?
I want formula to calculate current loss with distance in km.I searched many sites but didn't right answer.Plz reply me
what is smartµ grid technology?under coal gassification?
what is the difference between b c d curves on mcb
