Interested to Buy Any Domain ? << Click Here >> for more details...
Why distribution transformer secondary voltage is 0.433kV
instead of 0.415kV.all other switchgear rating are 415
volt??
- 3 Answers
- 9270 Views
- I also Faced
- E-Mail Answers
Answer Posted / saravanavadivel
The distance between distribution transformer and switch
gear is slightly more,in that distance voltage drop is
occured
Some times in switch gear we need a single phase supply,
if it is 433 volt means, the phase voltage is 250 volt,in
case of 415 volt ,the phase voltage is 239 volt.
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
How to maintain ac plant?
please send the IS strandard for electrical to sakthi_murugan86@yahoo.co.in
1. Can a 12v DC choke operate a 60v/12w PL lamp ? 2. Can a 230v ballast fire / operate a 60v/12w PL lamps.
how much UPS neutral erath leakage current.
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
What about electrical Units. discrive in detail
why the pf of semiconductor device is improved the electrical devices
What are the disadvantages of hydropower?
Explain the laying procedure and laying depth of submarine/subsea power cable for 220/400KV system? Also available cable diameter?
what is the necessary of using inductance property in transmission lines even through resistance is used to opposes the high current flows in that?????
SUTIABLE FOR ohm's law super conductor
What is meant by bus bar protection?
Whats the minimum value for I.R. that can be allowed for HT & LT alternators for operation?
If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????
