Interested to Buy Any Domain ? << Click Here >> for more details...
what happens if dc supply is given to the transformer?
- 10 Answers
- 17812 Views
- I also Faced
- E-Mail Answers
Answer Posted / raul
if a dc supply is applied across a transformer, there will
b no transfer of power from primary to secondary through d
core bcoz by applying dc there will no change in flux and
hence no emf produced in d primary by self-induction, no
magnetisation of the core and hence no emf in d secondary
by mutual induction.......so overall there will be no
transformation of energy from primary to secondary
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
star delta starter contorl circuit... drawing..
how you configure motorvision relay (L&T make)from DCS
i m doing DEEE in part time,can i join regular cources in BE,,IF i join what the cources can i select like (civil,ece,IT) ,,kindly advice
8. A DYNAMOMETER TYPE WATTMETER RESPONDS TO THE.......
What is ferro-resonance in electrical system? Why it occurs and what are measures to prevent it?
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
how many current required for hypo test
what is the difference b/w ATS and HTS?
what is invertor supply and raw powersupply
What type of core material is used for metering C.T and protection C.T???
How to calculate Air conditioning capacity for a telecom BTS shelter?
Why do we perform an open-circuit test and short-circuit test on the transformer?
How to calulate Locked rotor amper(LRA) for compressor type motors?
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
