Interested to Buy Any Domain ? << Click Here >> for more details...
in the pipe line if the control valve fails to respond to
controller action,by what means we can stop the flow in the
pipe line ?
- 9 Answers
- 11571 Views
- I also Faced
- E-Mail Answers
Answer Posted / mrmk
Good Suggestion.But if a control valve fail to operate
there may be so many reason.In practical,If you want to
isolate/stop the flow immediately it can be done easily by
closing upstream isolation valve.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
why orfice is not used for main steam flow calculation
if my flow is 20000 m3/h than which range of DPT i have to use????
What is instrumentation technologists and mechanics?
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
Any one can help me to identified, how can we interchange the device in FF
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?
how to calculate signal cable sizing? and multipair cable sizing??explain in brief?
Whether the DI, DOs shields can be connected with Analog Input Shield Earthpit?
how to turbine speed measurement?
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
I have a Control VAlve having size of 2 ".Only the known parameter is Pressure drop . Its 2 Kg. Then How to calculate control valve sizing means Cv.
Q- What are the application in which PNP transistor is preferred over NPN ?
How to check vortex flow meter is in good condition while we do not having calibration setup?
