Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / surendra
1. due to insulation cost.
2. for high voltage generation flux shuld be more for const
freq. thtwhy size of m/c become large which is not
economical.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to calculate the phase to phase clearness of HT /// LT bus bar?????
Why reactors use before incoming of ac vvfd drive?
how can we change the phase angle b/w two phase?
WHAT ARE THE EFFECTS OF SERIES RESONANCE AND PARALLEL RESONANCE ON THE CIRCUITS PARAMETERS?
what is the terminal voltage of dc series generator running at rated speed at no load?
What is the formula to calculate the rating of a three phase air circuit breaker
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
why we use ac supply as 415 volts instead of 415 v why we cant apply 230 v for dc
transformer phasor diagram under load explain it?
Draw a block diagramof Three UPS systems connected in Parallel mode?
Transformer how to maintaince a check b check c check d check
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
Distinguish between nuclear power station with thermal power station for initial cost, starting period, cleanliness, and transportation of fuel
where is the need for short circuit test for 3 see is required and why? can you explain in brief with application
what is the difference between an alternator and a synchronous motor
