Interested to Buy Any Domain ? << Click Here >> for more details...
we are using three transformer 33000/430 vac for three
separet block.all three transformer have three LT panel
separetly. can be Interconnected all three panel through bus
coupler. this is permissable or not by state electricity board.
- 4 Answers
- 6513 Views
- Piramal Healthcare, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
It is permitted if you have individual self protected switch
gears for outgoing feeders
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How shall i select the value of capacitor or inductor in a system?
What is phase cross over frequency?
why the frequency and voltage in india is 230v and 50HZ. when compared to USA say 110v and 60 HZ.
Where can I get Iidian straderd specifications for electrical items or works in web? please help me.
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
why Y CONNECTION IS BETTER INTERMS OF EFFICIENCY AND P.F FOR A LAOD LESS THAN 40% AND WHY AFTER DELTA IS BETTER FOR > 40%
WHAT IS THE PARTIAL DISCHARGE TEST?
What is the ideal position cooling fan inside the dc motor?
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
Explain about technical and non technical losses in distribution system?
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
What is the effect of positive feedback on stability of the system?
When will you multiply and devide with derating factors to the actual value while sizing the cable?
How will calculate losses in an multi core Aluminium LT cable of different sizes & upto what length we can use a LT Cable ?
