Interested to Buy Any Domain ? << Click Here >> for more details...
why, when birds sit on transmission lines or current wires
doesn't get shock?
- 36 Answers
- 57390 Views
- College School Exams Tests, Infosys, I also Faced
- E-Mail Answers
Answer Posted / akash
Because the the current flowing inside the wire
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Explain difference between stand by earth fault and residual earth fault protection?
when generator short circuit condition, the current how dissipates. or at short circuit voltage not available then current how can flow?
what is cascade speed control device?and how this device control the speed of motors?
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
previous year paper of ntpc bhel for degree in electrical enng
which pump used in STP
thyristor controlled APFC panel design parameter?
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
HOW THE OLTC TRANSFORMER SAVE ENERGY IN COMPARISON TO OFF LINE TRANSFORMER AND IS IT ECONOMICAL TO REPLACE THE OFF LINE TRANSFORMER TO OLTC TRANSFORMER
what is the profesional board for electrical engineer what is thepast and during construction for electrical engineering
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
In the formula : Knee point voltage = Burden X alf / class, Please inform what is alf? regards Shashidhar M.R.
tan delta equation test on alternators
what are the disadvantages in GIS over AIS
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
