What is Procedure the procedure to select CT's & PT's in
66kV and above substation?
- 3 Answers
- 10415 Views
- Infotech, Vijai Electricals, I also Faced
- E-Mail Answers
Answer Posted / rambabu
above is correct but the ct is current transformer for
measuring current and pt is measuring voltage in
sub-stations.these are using in HT sub stations only 1100v
and above.
| Is This Answer Correct ? | 11 Yes | 6 No |
Post New Answer View All Answers
HOW TO CALCULATE EARTHING SIZING?
when 20hp 3 phase motor start no load condition in star or delta connection.find current and write formula.(tariq)
how to calculate fuse rating for a motor
what is ps impedance test
how is the cable tray designed & how its total length is calculated for an Industrial plant Say for Ex. (500KW Motor Load)
to vary valtage from 0 - max a variac is necessary . so how to design for high power applications nearly about 200KW power
How do u analyse protection fault when vcb tripping on load
Could Please Explain briefly. Why used stabilizing resistance series with High impedance bus differential protection relay.
FOR 16/20 MVA 132/33 KV ONAN/ONAF TYPE TRANSFORMER IT IS DESIGNED FOR 16 MVA WITH ONAN CONDITION.IT BECOMES 20 MVA UNDER ONAF CONDITION.LOAD LOSS IS GUARANTEED FOR 65KW AT 20 MVA AND % IMPEDANCE 13.75. PLEASE TELL US AT WHAT LOAD LOSS AND % IMPEDANCE IT SHOULD BE DESIGNED FOR 16 MVA AND WHAT WILL BE ITS EFFICIENCY AT 20 MVA?
Importance of fault current in power transformers and how to monitor the same? How is it different from winding temperature?
Y phase plates are used in transmission line??? what is there need???
what is star delta starter? how it works? give its control and power diagram.
Name the types of motors used in vacuum cleaners, phonographic appliances, vending machines,refrigerators, rolling mills, lathes, power factor improvement and cranes.
Differentiate between Zero and Negative sequence current
How can you sized or estimate the ligthning arrester current rating?
