WHAT ARE THE FACTORS REQUIRED FOR SELECTION OF TRANSFORMER
RATING?
Answer Posted / shaista
SECONDARY LOAD VOLTAGE
KVA Rating
application of use
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is the maximum percentage voltage drop (vd%)for a motor control center
How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
How calculated single phase induction motor req. Capacitor?
700KW 6.6KV slip ring induction motor to use VFD to control the speed
From what on-site components does the HT panel monitoring the bus-bars in a 11kV system take inputs?
1. Can a 12v DC choke operate a 60v/12w PL lamp ? 2. Can a 230v ballast fire / operate a 60v/12w PL lamps.
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
Hoe do calculate the Cable size for Amps rating ?
What is bode plot?
what topics we have to concentrate for power grid et.written test.and tell what to read for english synonyms and antonyms.
What is meant by earthhing of a magnetic flow meter and when to use empty pipe detection?
What is transient response?