Answer Posted / sarvamangala

Please note that the mix design and water cement ratio
depending upon various factors, such as type of cement,
aggregate, site conditions, etc.
The mix design provided here is for reference purpose only.
Actual site conditions vary and thus this should be adjusted
as per the location and other factors
Ratio's are like this,
Cement:Fine aggregate(Kg/m3):Coarse aggregate(kg/m3):Water
(l/m3):Plasticizer (l/m3)

1) M60: 1:1.35:2.19:0.29:0.8

2) M50: 1:1.472:3.043:0.35:0.012

3) M40: 1:1.65:2.92:0.4:0.006

4) M35: 1:1.76:3.18:0.4:0.005

5) M30: 1:1.87:3.38:0.42:0.005

6) M20: 1:2.4:4.93:0.5:nil

Thank you

What is the crank length in the slab?

1016

---

What are the different theories of failure under static load?

1239

---

what is the ingredient value of 40mm and 20mm aggregates?

1943

---

Why are steel plates inserted inside bearings in elastomeric bearing?

1238

---

Advantage of Aluminum form work in terms of activities can be skip and cost too

1006

---

Define What are the reasons for geotechnical site investigations in Uganda?

1110

---

How can we make a hole in a solid rectangle using solidsworks?

1208

---

Used Cement & Sand in 1 Square Meter or 1 Square Feet For Brick Work 0.115mm ? (1:4) (1:6)

2390

---

In Abutment walls (A1 side) why we are adopting fixed bearing (POT-PTFE)?

2030

---

what radial pressure, the NP2 class rcc pipe can sustain?

3327

---

How much permissible bearing capacity requires for open footings(isolated) and what type pile foundatuon prefering for coastal areas?

1940

---

what is the difference b/w full length and cutting length?

2176

---

how to calculate load bearing column

3526

---

How to calculate carrying capacity of the existing water supply trunkmain

2246

---

How much quantity of cement and sand required for the inlining of 610mm dia MS pipe 8.7mm thk.Inlining thickness is 10mm and CM ratio is 1:1.5.

4153

---