WHAT IS THE THUMB RULE FOR DECIDING THE CURRENT RATING OF
COPPER WIRES SAY 2.5/4/6/10 MM SQUARE SIZES??
Answer Posted / sonu
current carrying capacity of wire's of
2.5 sq.mm=29amp
4.0 sq.mm=37amp
6.0 sq.mm=48amp
10.0 sq.mm=66amp
Is This Answer Correct ? | 28 Yes | 38 No |
Post New Answer View All Answers
Explain the working of any one cutting machine
how to calculate
what are the different methods for the starting of a synchronous motor.
What happen Grid EARTH plat got cut.
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
Testing procedure of DG alternator stability test
What is MSL designation of a motor and same may be provided in details.
What are motor generator sets and explain the different ways the motor generator set can be used ?
which type of stability limit is higher,steady state or transient? why?
What are the advantages of autotransformer?
What is Electrical Grade Aluminum for Tubular BusBars. i am confused between 6063 and T6 or T5 and what is BS 2898 and BS 159?
What is the difference between type1 and type2 relay protection co-ordination for motor feeders
how can maintaince the acb contactor moveing and fixing kit
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?