While connecting the flood light plug on to the 415 V
distribution panel,there was spark and the cable got burnt.
Three ignitors of the flood light also burnt of. The lamps
are of 400 W (total 6 lamps) connected through 1.5 mm2
cable. The plug was immediately removed from the circuit.
There was a 30 mA RCD connected and a 250 A MCCB; however
both did not trip. What could be the possible reasons for
the circuit devices not to trip?Can someone assist please.
Additional info if needed can be provided.
Answer Posted / albaloshi4u
check flood light another distribution box whether your flood light is working properly or faulty and also check your db phase voltage.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what will be d.g. capacity to cater together for 14hp A.C. load & 3kw lighting load
can indirect loading be called as phantom loading?
boiler is running in rankine cycle and deisel generator is....?
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
would the same effect be achieved by reversing the connection to one winding of the induction motor 3-phase?
what is the importance of earthing system on the generators big capacity and small?
why ss stablity limit is more transient stablity limit?
What are the advantages of vscf wind electrical system?
Is it advantages of having star-delta vfd than normal star vfd , if yes why?
Do Phase angle measurement have any application in freq/harmonics measurement? If so how?
What is meant by full pitched winding?
state basic meaning of 'INDUSTIAL AUTOMATION'?
What is the type of earth fault protection used in battery? explain.
how we findout a ignater is faulty or not?
Explain dc generator with its types?