Interested to Buy Any Domain ? << Click Here >> for more details...
What are the necessary conditions for production of
rotating magnetic field.
- 4 Answers
- 9940 Views
- BARC, I also Faced
- E-Mail Answers
Answer Posted / surendra pratap
polly phase winding displace at certain angle mechanically
as well as electrically and carrying polly phase current.
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
plz explain the auot-reclosing circuit in electrical engineeing
sir, iam a electrical engg graduate and i want to go in automation sector and for this i have decided to do industrial training for this,plz suggest me some good institute for the same in delhi,ncr. my degree percentage is 58%, can i get job after doing training, plz help....
What is a DC series motor?
What is oscillator circuit?
how r charge carriers produced
What is the height of DA, DAL, DB, DC & DDE tower?
What is the permissable nutral current of three phase system as per IS standards?
how does commutator convert a.c to d.c?
what is the difference between electrical and electronic choke?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?
sugest any typical project ?
if field breaker of generator is closed prior to its rated speed on a power generating unit. what will be the effect on generator, unit transformer and starting transformer.
An automatic water heater is an example of which type of control system?
