Interested to Buy Any Domain ? << Click Here >> for more details...
how do we connect mcb in our home?and how does it work?
- 3 Answers
- 15248 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / geetanjali chawla
we connect mcb in series with load in our home .when there
is short circuit or open circuit then mcb contacts will be
open and the circuit will trip.In this way it protects our
home appliances
| Is This Answer Correct ? | 12 Yes | 12 No |
Post New Answer View All Answers
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
Inductor and capacitor........power in one phase and ...... in it another phase.
Why do power lines not short out when they fall into water?
why and where we use early make & late break contacts in protection?
The ripple frequency in output of fullwave bridge rectifier is a. Half the input b. Twice the input c. Same as input
Differentiate between kirchhoff’s first law and kirchhoff’s second law?
Explain the different methods used in the choice of rotor slots for reduction of harmonic torques in an induction motor.
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
how to control the speed to switched reluctance motor
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
why single phase to grd test in HV cable?why not 2 phase at a time?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
I want single line diagram for AMF & DG syncronizing panel
