Interested to Buy Any Domain ? << Click Here >> for more details...
why ac generator ratings in kva only why not kw ?????????????
?
- 7 Answers
- 13376 Views
- I also Faced
- E-Mail Answers
Answer Posted / raul
the designs and ratings of electric machines such as
alternators, transformers etc are always decided by the
amount of losses taking place in d machines i.e. core loss
and copper loss. since the core loss depends upon the
applied voltage and copper loss depends upon d load
current, therefore the product of these dependent variables
i.e. voltage and current i.e. KVA is the acutal ratings.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
What is given by the definition in BIL IMP/PF = 950/395 kV. This was found in a name plate of a power transformer.
WHAT IS MEANT BY DERATING OF THYRISTOR?
What is relation between mu(nought) and epsilon(nought)?
Explain how to determine capacitor tolerance codes?
Pls Breifly explain about UPS (Inverter,Reserve,Rectifier,Float voltage,Boost voltage).
what are the applications of transistors with low dc gain, high dc gain and medium dc gain( beta)?
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
What is the difference between electrical earthing and electrical grounding?
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
What id difference between power and energy?
How to check the cable fault / hv test of transformer cable.
How to decide the size of the capacitor for a single phase induction motor say 2 HP ??
The power supplied to a 33microF capacitor from a 120V, 60Hz source will be
why we testing the core balance of the transformer before comissioning?
