why does not tester light up when it is touched to neutral of
3 pin socket.
- 4 Answers
- 18325 Views
- I also Faced
- E-Mail Answers
Answer Posted / jaswinder singh
Tester always lights up due to potential difference between
phase and earth. Neutral is at zero potential from earth so
the tester does not glow.
| Is This Answer Correct ? | 10 Yes | 4 No |
Post New Answer View All Answers
(1)The demand for electricity , the amount of renewable generation available, the amount of fossil fuel generation available and the cost of the fossil fuel generation are shown in table below period(hrs) demand(MW) renewable (MW) fossil- fuel(MW) cost of fossil fuel(MW) 00.00 - 01.00 2000 1800 2000 30 01.00 - 02.00 2300 2500 2000 30 02.00 - 03.00 2500 2700 2100 45 03.00 - 04.00 2900 3100 2100 50 04.00 - 05.00 2700 2600 2500 45 05.00 - 06.00 2400 2000 2700 50 06.00 - 07.00 2200 1800 2000 36 07.00 - 08.00 2100 1600 2000 36 Assuming that the renewable generation incurs zero cost, determine an optimal generation schedule(specifying the amount of renewable generation and fossil fuel generation used in each period, the cost for each period and the overall cost for 8 hours.)
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
Differentiate between voltage and current feedback in amplifiers?
why ht motors are star connected?
do we use links in a dc circuit?if so what s its use in it?
What will be the output voltage of a transformer if it is primarily energized from a square wave voltage source?
What do you mean by ratio correction factor of instrument transformer?
Explain the process of commutation in a dc machine.
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
What is the difference between single core 2 wire and single core 3 wire system? Which application we are using this? and for What purpose we are using this?
please send privious years question papers of jindal steel and power ltd.My e mail id is rajanikant.sngh@gmail.com
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
Brief me about maintenance planning & sheduling of machine tool.
We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?
Why frame of the motor is specified?. If we mention KW and voltage level,automatically frame is decided or separately frame is compulsory to mention?.
