Why is making current of CB always greater than CB breaking burrent?.
Answer Posted / sudar
Which one more save opening CB at capasitive or inductive
condition???
Is This Answer Correct ? | 2 Yes | 8 No |
Post New Answer View All Answers
In which working principal temperature transmitter work.explain in detailed.
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
why industry prefer ht motor instead of lt motor.
What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.
what is transient enclosure vltage , very fast transients, very fast transient over voltages
Match the following a)(X'+Y') b)X'Y' C)XY 1)NAND 2)NOR 3)Carry
what are pilot cells
how to select proper cable for ct wiring so that drop within the limit.
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
DIFFERENCE BETWEEN NORMAL TRAFO AND THRISTER TRAFO?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
How you calculating the 30 Hp 3 phase AC motor of power what size of cable is used for this motor?
how is control wiring coding is done in a CRP panel ?
what is excitation/
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)