What is 100%
protection of
generator? Why
95% protection
is used not 100%?
Answer Posted / dayanidhikinkar
since few turns of wdg have very small voltage therefore
fault current flowing through secondary of CT is less than
preset value for relay operation.Hence relay will not
operate for that much portion of winding.
| Is This Answer Correct ? | 11 Yes | 8 No |
Post New Answer View All Answers
What is cut-off rate?
Can 33kva/415v transformer be run underground? If the answer is yes why and if the answer is no why?
How two nos. 130 kw D.C motor get synchronise using D.C drive.
How will you define capacitance?
DG SET BLOCK DIGRAM
List advantges of active filter over passive filter?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
which protection used in power plant?
Difference between transition and diffusion capacitance
Will an earth leakage trip be activated if the component or wiring is faulty on low voltage equipment.Example An electrical Cat Scarer placed in the garden and water gets into the wiring.
What is the difference between circuit breaker and isolator
What is difference between slip rings and carbon burushes?
how to failure indution motor insulation & how to improve heat in motor insulation
what is the transformer rush current?