what is the difference betweem star connected motor & delta
connected motor?
- 13 Answers
- 91245 Views
- I also Faced
- E-Mail Answers
Answer Posted / joseph james
In star connected motors power consumption will be less
compared to delta connected motors.
| Is This Answer Correct ? | 45 Yes | 22 No |
Post New Answer View All Answers
What is VCB? where it is installed at SP. What is SP?
how we design a pannel to start 10HP motor with the help of star delta starter?
i have a 1500kVA transformer what is the kWH meter i need to use?
If ROC does not lies inside unit circle,then ? a) Fourier transform converges b) Z transform converges c) Hatly transform converges d) Colpit Transform converges.
WHTA IS LIMT OF LEAKGE CURRENT OF 11 KV 1 CORE 1000SQ.MM. XLPE CABLE.LOAD ON CABLE IS AROUND 600AMP .LENGTH 500 MTRS.
how to i get B licence,i am completed BE electircal and electronics engineering.i want to konw the proceduure to get b licence
I am about to write exam in RRB bangalore for the post of section engineer.please provide me with previous exam questions
How To Convert Apparent Into Real Power Without Knowing Reactive Power?
I have a 380 KVA DG set. How can i find out 1. My Fuel Consumption per hr ? 2. Electricity produced in 1 Hr. ? 3. If load varies then how does it affect fuel consumption & electricity produced ? Please HELP !!! Really need an answer.
Help need in transformer !? Hello Friends The parameters of 2300/230 v 50hz t/f is R1=0.286 ohm R`2=0.319 ohm Rc=240 ohm X1=0.73 ohm X`2=0.73 ohm Xm=49.2 ohm Secondary Load impedance ZL=0.387+J0.29 solve the exact equivalent circuit with normal voltage across primery.. I know every thing but i cant find CURRENT I1=? and I`2=? Please help me give solution or only Formula please please...
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
What will happen to the protection and metering, if the polarity of a single or two PT/PTs in three phase system is reversed? Please provide reference if any.
pre arcing time of ehv breaker
How to select the proper VSD to operate high inertial load
why we r not earthed Control cable of C.T. terminals
