Interested to Buy Any Domain ? << Click Here >> for more details...
Whats meant by trivector meter where it is connected at the
substation?
- 20 Answers
- 114694 Views
- GPIL, Infosys, Jakson, L&T, Secure Meters, I also Faced
- E-Mail Answers
Answer Posted / sundar
I too here not giving answer, but i want know more about that two quadrant and four quadrant form Mr.Shankar Malagamma.Sir can you explain that in detail.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What are the basic elements used for modeling mechanical translational system?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
What is difference between SMC supportg and Glass Fibre Reinforced Plastic Support.
List the advantages of star-delta starter with induction motor?
What is the function of the generator exciter?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What is touch potential and step potential?
what are the advantage and dis-advantage of 3 phase 4 wire energy meter?
How you will determine the volume of oil in a particular Distribution transformer.
What is NGR . What is the purpose of 10 sec ,60 sec rating of NGR.
oil cooled transformer
how to control dc motor?
how are reversing the direction of rotation of dc motor
how to produsing geretor power
The ripple frequency in output of fullwave bridge rectifier is a. Half the input b. Twice the input c. Same as input
