How do we check transformer losses and what are the ways to
minimise it.
- 5 Answers
- 13810 Views
- I also Faced
- E-Mail Answers
Answer Posted / achala.g.s.
We can check like the following :
polarity, resistance and tap change operation tests should me made to check whether it has built correctly or not..
the ways to minimize it are:
*check of Oil quality.
*A check on the tap changer.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
if any house we instaled a 1.5 ton ac and its phase cable of wiring is installed but netrual cable of wiring not instaed. my question is that is neutual of house(for other wiring is capable for ac load or a sepeart neutrual wiring required
What we mean by vintage of an engine+Generator?
what is the electrical?
Whether it is possible to measure energy at the input of rectifier transformer (12 pulse with very high odd harmonics)
There is any especial requirement for motor to drive through with VFD?
how can we save enegry by using VFD for Resiprocating Air compressor which is having more unloading running hours
HOW TO CALCULATE HV TEST VOLTAGE FOR ELECTRICAL EQPT.
What is bode plot?
What are books to be referred for KPTCL exam?
What is transient response?
What will happen if the d.c. Machine is operated below rated speed?
what happen if field of dc shunt motor opens? what is function of putting res. in parallel to one phase of 3 phase IM? the power supplied by 5A source in circuit is given by------Watt.
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
Lt motor sfu flashing reasons?
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
