why the autotransformer burnt while stating the pumpmotor?,
In starter and motor there was no abnormality.
- 4 Answers
- 12420 Views
- I also Faced
- E-Mail Answers
Answer Posted / pillay
a)Loose terminations at the auto transformer itself .
b)intermittent failure of the change over timer or starter.
c)excessive load at time of starting .
d)insulation failure of the auto transformer.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
how is the cable tray designed & how its total length is calculated for an Industrial plant Say for Ex. (500KW Motor Load)
why different series of vfds (like allenbradley)are used in industry ?
What is block diagram?
2. A current i=(10+10 sin t)amperes is passed through MI type ammeter. its reading will be.........
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
Explain dc generator with its types?
How to Decide the Location of Earth pit for Compressor in Oil Depo? and How to measure the resistance of earth pit Pls explain me with the help of Circuit Diagram?
neutral earth resistance testing is it possible for transformer while in load condition
what is the calculation formula for motor starting torque,running torque, running torque.
will there be any problem by recovering slip from single phase induction motors?
what is the Earth Voltages in Power Plants, Sub-stations, Industries, Residential & Commercial Buildings.
what will happen if the prime mover on the field excitation of the on-coming generator fails?Explain.
What are the special cables required for explosion proof wiring?
What is phase cross over frequency?
