Interested to Buy Any Domain ? << Click Here >> for more details...
What will be the size of cable required for 5.5 KW motor (
Full load current 10 Amps approx.), Starting current with
DOL is 120 Amps. Aprrox. Short circuit current with LLLG
fault is 2000 Amps Approx.
- 2 Answers
- 26385 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
6 sq mm copper cable and 10 sq mm if the usage is
non-stop.cables can withstand heavy currents for short periods.
| Is This Answer Correct ? | 17 Yes | 3 No |
Post New Answer View All Answers
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
What is ferro-resonance in electrical system? Why it occurs and what are measures to prevent it?
what is the difference between "Rotary bypass isolation switch and Normal bypass switch" pls share indepth techs?
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
I need HT sphere gap calibration table. Can any body help me.
what percent do you derate your copper wire when you change from copper buss to copper wire
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
Draw the circuit of clapp oscillator?
how much LT load can bear by the 100 KW HT connection.
How to calculate the efficiency of Turbo Generator(Alternator) in general....?
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
What is servo motor? what is its purpose?
why are the maintaine power factor and how can this control and this is how work.
If a transformer primary winding operates at 240v, the secondary at 120v and the load is 1500w & the transformer is rated at 92% efficient, what's the current flowing through the primary winding of the transformer? What is the formula for finding this?
