Interested to Buy Any Domain ? << Click Here >> for more details...
how can findout cable fault Location only useing MEGGER
- 3 Answers
- 7598 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
With megger you can find out whether the cable is faulty or
not ,but you can not locate it in the cable ,for which a
separate equipment is available.
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
apti mainly on logical reasoning, verbal and non-verbal ability (70 percent) and remaining technical. I was in ee but technical had mech ques like on turbines and welding.
Transmission through a short line depends on
How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?
How to test lightning Arrester?
How to calculate the efficiency of Turbo Generator(Alternator) in general....?
What is different between Circuit breaker and Isolater?
What is effect of over voltage and under voltage on ACB
how to design the heater in temperature control unit to heat 50KL of water?
whate is the meaning of balance/unbalance,in stabilizers type
what is d check in dg 1500kva
what questions are asked in the interview for the post of an electrical maintenance engineer in FMCG companies?
Difference between low impedance and high impedance Restricted Earth Fault
how to failure indution motor insulation & how to improve heat in motor insulation
What are the parts in a inverter?
For RCD (Residual current device) Icu is defined. How i can find Ics for them?
