what is droop mode n frequency mode in wood ward governor?
- 1 Answers
- 5605 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / sagar mohanty
the isochronous governors cannot be used when there are 2 or more units connected to the same system. since each generators whould have to have pricesely the same speed setting. otherwise they would fight each other, each trying to control system frequency to its own setting.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What are the application of bernoulli’s theorem?
what is the process for double acting cylinder pneumatic for 32' v/v
Positioner usage.
How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System
what are the values of fuel flow rate in various places in boiler.
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
Explain the key components of control loop?
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
Meaning of the following a. IOP- Manimum; b. IOP- Maximu,;
field bus transmitter calibration procedure tell me
Draw a great bridge circuit.
How hart protocol can be connected with control valves?
how to calibrate load cell
what is the current pay package for an instrumentation engineer having 2 years of experience in cryogenic technology???????
