Answer Posted / k.prakashchandra
Depends on rated current and phases
Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
What is the difference between DOL starter and star delta starter
What is A check, B check, C Check & D check for a diesel Generat
How npn and pnp transistor works
what is motor capacity of 80TR chiller? and also say what is the formula related temperature, motor capacity, TR?
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
In DC generator, we use commutator, having no. of segments. Then how it is possible to get a half wave of voltage and current for half rotation of armature?
what is kvarh? Please define it With calculation General motors ?
WHICH SIZE A.B.CABLE IS USED FOR 11KV.
why high speed tripping relay is used in protection circuit why not normal relay
Why in ESP Positive earthed
what is a reactive power? what is the relation with power factor?
i m electrical diploma holder i want to do plc $ Scada some body tell me which insitute is best for me near chandigarh
How we can calculate the consumption in kwh of motor on basis of kw @100% load, @50% load & @ no load.
what will happen reduce the transformer voltage from 415v to 406v, is it save the energy,? are this methodis good to reduce the energy.?