why normally Generator rating are between 11Kv to 22Kv?
- 7 Answers
- 16482 Views
- Torrent Power, I also Faced
- E-Mail Answers
Answer Posted / raji g
in electrical power generation side they produce large
amount of power that means that generator windings carry
very large amount of current for low voltages like 440. if
we use 11kv the current in alternator windings is
reduced....hence usually high range of voltages are used in
power generation side
| Is This Answer Correct ? | 11 Yes | 7 No |
Post New Answer View All Answers
What is the effect of positive feedback on stability of the system?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
PLZ sent the previous year question paper for GET in NHPC on my EMail id ppshanker@gmail.com
at what basis/standard we have to arrive the current density of aluminium/ copper in busbar?
although ckt breakers have taken the place of old fuse. But instead of it , these older ones are still used in the industries and homes ? why .... what are their advantages and disadvantages ? which one is leading and winning the race and competition ?
please send privious years question papers of jindal steel and power ltd.My e mail id is rajanikant.sngh@gmail.com
i m electrical diploma holder i want to do plc $ Scada some body tell me which insitute is best for me near chandigarh
Is it possible to download the Siemens Selection Chart(TYPE 2 coordination) for 1) fuseless selection 2)Fuse selection
what is the reason the main breaker is trip during the motor is running? (some time the breaker is not trip)
Why is the air gap between the pole pieces and the armature kept very small?
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
What will be advantage if we put some load in neutral of grounded star transformer & loadshortcircuit current,rated current of cable & MCB with example?
How grounding is different than earthings?
Tell me in detail about c.t. And p.t. ?
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
