Interested to Buy Any Domain ? << Click Here >> for more details...
why normally Generator rating are between 11Kv to 22Kv?
- 7 Answers
- 18325 Views
- Torrent Power, I also Faced
- E-Mail Answers
Answer Posted / gaurav tripathi
because mostly power is generated between this voltage
| Is This Answer Correct ? | 7 Yes | 17 No |
Post New Answer View All Answers
how we can calculate power factor in single phase & three phase ?thank u
What is electrical grounding?
How to calculate the volumetric capacity of a oxygen & Nitrogen gas Cylinder if pressure is 145 kg/cm2 & water capacity of cylinder is 67 liters.
How to detect voltage vector shifting in interconnection protection.
What are your personal skills and abilities for such a Master Course and your possible preparation to undertake this course?
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
Lt motor sfu flashing reasons?
why swinburnes test cannot be performed on series machines?explain
what is the electrical?
what percent do you derate your copper wire when you change from copper buss to copper wire
What is cross over distortion? How it can be eliminated?
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
what will happen if i connect 12 volt battery with 24 volt battery charger.
why the electrolyte level in lead acid battery is maintained 2.5 cms above electrodes?
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
