Interested to Buy Any Domain ? << Click Here >> for more details...
what is the earthing condition between earth & phase.
- 3 Answers
- 6232 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / bhaskar.j
The earthing condition is zero between earth & phase because
when it is touched, it gets tripped or blown off
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
he compression ratio for a petrol engine generally lies between
bsnl tta exam question
when qty of cable being purchased is not sufficient according to the standard,what should the inspector do to ensure its quality according to the standard?
HOW CAN WE DECIDE THE SUPPLY VOLTAGE FOR MOTOR ACCORDING TO ITS RATING(IF ANYONE KNOWS GIVE IT WITH EXAMPLE AND ITS CALCULATIONS)
why do we have spikes enough to burn electronic boards, when generators are not grounded
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
Why the unit sizes of hydro generating machines are not standardized as in case of thermal powerplants?
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
What is the meaning of utility ground and clean ground? How the distribution panel is grounded?
why we use 630mm single core cable for transformer secondary side and why two neutral cable
show the single line diagram of star delta starter with single phase preventer
is it possible to turn on the single phase star delta on delay timer using 24 v dc ?
Why air circuit breaker off due to power failure?
How can we calculate cable size in Low voltage & high voltage
