Interested to Buy Any Domain ? << Click Here >> for more details...
if one of the phase is failed to 3 phase IM. what will happen?
- 6 Answers
- 9450 Views
- I also Faced
- E-Mail Answers
Answer Posted / abhishek sinha
motor runs for some time with less speed because one of the
phase is gone and current increases in two phases,after
some time if no protection act than motor will burn.
| Is This Answer Correct ? | 12 Yes | 0 No |
Post New Answer View All Answers
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
how we can calculate chiller required ampear?
please give me all the Alarm .Trip ,Safety Relays & Conditions of Diesel-generators mail me on ashokbabunhce@gmail.com
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
i need some project topics along with circuit diagram in the electrical adnd electronics engg and also give ome website regarding projects.my mail id is thenmozhi2k7@gmail.com .please help me.
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
How to calculate the phase to phase clearness of HT /// LT bus bar?????
what is the relationship between current&voltage in practical purpose ?
can we find the inductance of a induction motor?
Why using synchronising methed in DG's sets?
What will happened if the neutral of secondary of Xformer ( Star point) Note it's above KVA rated Xformer
What is the mechanism of WTI
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
What is CCT (Correlated Color Temperature) ?
What is the best thing to protect the motor from running over full current. CT or O/L or pressure transducer at the given pressure rating
