if one of the phase is failed to 3 phase IM. what will happen?
- 6 Answers
- 7308 Views
- I also Faced
- E-Mail Answers
Answer Posted / b2
it will be run but not for mor time and after some time it
will be burn out
| Is This Answer Correct ? | 16 Yes | 0 No |
Post New Answer View All Answers
What is the count of hvdc transmission lines in india?
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
What is inverse definite minimum time lag relay? Where is it use?
How much minimum insulation required between 11kv/3.3kv transformer windings?
WHY MOSTLY Rph IS USED FOR CONTROL CIRCUITS AUX. SUPPLY ?
what are the specifications we must look at to select a relay for any capacity motor?
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
what is the voltage regulation for unity and zero power factor?
what is the difference between c power and U power acb breaker
why ht motors are star connected?
WHY NUTRAL GROUND SYSTEM USED IN 33KV SYSTEM
bitumar
what is the string efficiency
What do you understand by external characteristics of a d.c. Generator?
How to calculate the no of Ceiling fan (1200mm sweep) per unit area?
