Answer Posted / anil kumar satri
THE BP DEVELOPED IN THE ENGINE IS DEPEND UPON THE AMOUNT OF
CHARGE ENTERING IN TO THE CYLINDER (VOLUMETRIC EFFICIENCY).
WE CAN DEVELOP THIS VOLUMETRIC EFFICIENCY BY TWO METHODS
1) SUPER CHARGING
2) TURBO CHARGING
SUPERCHARGING MEANS IT WILL COMPRESS THE AIR IN
COMPRESSOR, BEFORE SENDING INTO THE CYLINDER BY UTILIZING
THE POWER DEVELOPED BY THE ENGINE.
TURBO CHARGING MEANS ALSO SAME, BUT IT UTILIZES THE EXHAUST
GASES TEMPERATURE TO RUN THE COMPRESSOR.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
tell me about a type when you had to use your presentation skill to influence some ones opinion
When maximum discharge is obtained in nozzle ?
Is the unit and normal value fuel ratio of an average diesel engine?
What is the purpose of air blow?
Draw L.O. system in diesel engine?
What is wet corrosion and galvanic corrosion?
Sir i am appearing for the section engineer post examination of railway recruitment board.Can you please send me the previous question papers from 2001 to till date.
How many years did it take for you to complete school?
How to recommend which type of coupling is suitable in particular area
Given a cutaway isometric view of the steam turbine.
What is the thermal efficiency of a diesel engine?
What are the dimensionless parameters used in forced convection?
Causes of F.O. Purifier abnormal flow?
"When you will install a new piston ring, what will be the position of it?"
how to calculate duct fittings surface area ?
