Interested to Buy Any Domain ? << Click Here >> for more details...
If not into production, how far did you follow the design
and why did not you see it into production?
- 1 Answers
- 5186 Views
- Intel, I also Faced
- E-Mail Answers
Answer Posted / anm
Design is a general term,applicable in every field of
engineering.however production is termed as to follow up
the steps after design to make product available in the
market.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
Explain Cross section of an NMOS transistor?
what is a sequential circuit?
Write a VLSI program that implements a toll booth controller?
Calculate rise delay of a 3-input NAND gate driving a 3-input NOR gate through a 6mm long and 0.45m wide metal wire with sheet resistance R = 0.065 / and Cpermicron= 0.25 fF/m. The resistance and capacitance of the unit NMOS are 6.5k and 2.5fF. Use a 3 segment -model for the wire. Consider PMOS and NMOS size of reference inverter as 2 and 1 respectively. Use appropriate sizing for the NAND and NOR gate.
What is look up table in vlsi?
what is the use of defpararm?
What are the Factors affecting Power Consumption on a chip?
What are the different ways in which antenna violation can be prevented?
What are the Advantages and disadvantages of Mealy and Moore?
Differences between Array and Booth Multipliers?
What is Body Effect?
What are the changes that are provided to meet design power targets?
What is Latch Up? Explain Latch Up with cross section of a CMOS Inverter. How do you avoid Latch Up?
What work have you done on full chip Clock and Power distribution? What process technology and budgets were used?
How can you model a SRAM at RTL Level?
