purpose of centrifugal pump casing wear ring and impeller
wear ring
- 10 Answers
- 53031 Views
- Jyoti Ltd, Kirloskar, NPCIL, I also Faced
- E-Mail Answers
Answer Posted / rajeev singh
Dears,
First sorry for speling mistec.
Ans.- 1. cost factor.
2. keep safe of our casing and impeller.
3. Mainten the clearance beetwin impeller and casing.
guys we can mainten the clearenc without wearing
but think, you wich one esey reples the wearing
or, impeller and casing.
Rajeev Singh
Mechanicial Tech.
SAUDI KAYAN (KSA)
C.W.S
| Is This Answer Correct ? | 7 Yes | 10 No |
Post New Answer View All Answers
effect of temperature on stainless steel,aluminized steel,chromium at (500C-750C)-required for project work on silencer 1.thermal conductivity 2.heat conduction 3.mechanical strength 4.temperature to weight ratio urgent
What are the different theories of failure under static load, explain ?
if any one who attended the caterpillar interview please send me the sample questions and the areas from which questions are being asked...
3x3x2.5 m room temperature increases by 20 deg cel in 24 hours by a lamp of 100 w. then tell the temperature of the filament
how 2 prepae for technical aptitude? suggest me any books r
how can u increase the efficiency of a power plant without changing the effort?
Hello there, Im a Mechanical Engineer. I passed out in 2010 and have worked for 6 months in the Middle East as a Trainee Engineer. Im now in India and due to appear for an Interview for a firm in the Middle East. The post is of an Automobile Engineer. Im kinda nervous as to what to prepare for the interview. The training which I got was in different areas ranging from technical to managerial aspects. What I mean to say is that that was more of a crash training, where I couldn't stick to one section alone. The interview which Im attending is more of a technical one. What I would like to know, how and what I should be preparing? I have two weeks for the preparation. Should I go through the normal automobile aspects or everything in random. PS: I have excellent communication skills, the one area in which I'm very confident.
For which parts the wahl factor and lewis form factor used ?
If you have a valve with an applied pressure, how do you determine the stress to the closed and open valve?
respected sir, i had applied for the post of GET for JSPL so kindly send me the syllabus and exam pattern for the concerned examination. my mail id: starsunny49@gmail.com thanking you sir
PLESE SEND ME OLD TECHNICAL N APPTITUDE QUESTION PAPERS
Explain working of francis turbine?
Hai, iam renjith. my qtn about the calorex heat and cool pump. What is the reason of the above machine is trip on high pressure. r134a gas using in this system. 8 months old. model is calorex propac 90(3 phase). This system has 2 compressor. Both are starting on 13amps after that rise up to around 21 within 1 minute. After will be trip on high pressure. Showing 68 psi in suction side on standby mode. Can i have a solution without delay? Renjith renjithngm@gmail.com
How to check the round duct measurement
What is the specific gravity or relative density of fuel oil?
