Interested to Buy Any Domain ? << Click Here >> for more details...
New istallation how many eathing have one transformer?
Names of earthing connect places?
- 10 Answers
- 29341 Views
- I also Faced
- E-Mail Answers
Answer Posted / gaurav sinha
Any transformer should have atleat four earthings.
2 neutral earthing and
2 body earhtings
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
Define active filter?
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
Difference between low impedance and high impedance Restricted Earth Fault
what is the reqirred voltage in HT motor to get full RPM on no load test?
Distinguish between nuclear power station with thermal power station for initial cost, starting period, cleanliness, and transportation of fuel
how give earthing conection to household equipment?
Can any one know what are the symbols at the down (below) the analog ammeter??? there are 4 symbols which are they ?????
If not into production, how far did you follow the design and why did not you see it into production?
why in a swquence network representation, the negetive sequence generated voltage is taken as zero?
please send me previose rrb junior engineer qustion papers
How to size fuse? How to size MCB?
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
