what is bushing in transfermor
- 7 Answers
- 7094 Views
- Bokaro Steel, Visa Steel, I also Faced
- E-Mail Answers
Answer Posted / kabir0921
Bushing is an arrangement in transformer which provides the
path of conductor from high voltage line to transmission line.
It protects the transformer from flash over.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to erect roof control panel?
Can the output voltage of a rectifier be greater than the input AC voltage without the use of any voltage multiplier in the circuit??please provide the explanation too..
What cmos is and its benefits?
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
What is Anemometer used to measure?
what is the main difference between power devices and signal devices
How to test IR testing & magnetic balance test
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
What is the power factor of a transformer at no load?
all interview questions with answers of ntpc (2000-2009
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
What are the conditions to be satisfied for parallel operation of dc generators?
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?
What is the accepted limit to increase the choosen transformer capacity over the load and why ?
