Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / syed.yaseen
Capacitor is used to maintain power factor & Where as
ignitor is used to ignite the lamp which acts as a sparking
component to ignite the lamp.
| Is This Answer Correct ? | 21 Yes | 1 No |
Post New Answer View All Answers
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
What is the technical difference between On delay timer and a Star delta timer?
whati s the sludge current in ups
SUTIABLE FOR ohm's law super conductor
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
75 kw motor take 45 amp in no load delta in star 10 amp but in load it will take 160 amp but IR velue of winding above 500 at 1kw ph to earth and ph to ph. what problem it should be?
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
Cb closed condition if there is a tcs fail whether cb will trip or not
Is neutral transformer can be called as control transformer?
ASTM D 3455 - Standard Test Methods for Compatibility of Construction Material with Electrical Insulating Oil of Petroleum Origin has been used for Testing Transformer Oils with a product placed in it. Aged Control Oil has a Power Factor of 0.032% at 100°C. Aged Oil with a Test component has a Power Factor of 0.093% at 100°. Is this increase acceptable? If not why? How much increase is acceptable?
how to commissioning the genset with amf panel?
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
Is potential difference materials property ..? if yes tnen how.. explain brifly.
Explain the working of any one cutting machine
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?
